use GUID for setting partition element with bcdedit

The following is an example of a valid BCDEDIT command:

BCDEDIT /set {ntldr} /device partition=d:

If a disk were added to the system and the drive letter of the

partition just referenced was no longer "d:" then it would not

be found by the loader. 

Could a volume name such as

 \\?\Volume{e1e236ee8-7dbd-1223-a442-806d61f356de}

be used in place of the drive letter in the same command ?

(If not, my next question would be how to reset the

element in a script...perhaps some hints?)

Thank you.